Researchers in China have investigated how screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design intended to limit the damage, according to a study published in Solar Energy.
Screen printing is widely used to metallize solar cells, but the mechanical pressure and thermal treatment involved can damage the sensitive passivating contact structures of HJT devices, increasing recombination losses and lowering conversion efficiency. The question is especially relevant for copper-plated HJT cells, which are seen as a route to reducing metallization costs and dependence on silver.
Why photoresist printing differs from silver paste printing
Corresponding author Lang Zhou told pv magazine that applying photoresist by screen printing in HJT production differs fundamentally from conventional silver paste printing. In silver paste printing, he said, screen openings cover only 2–5% of the total area and the remaining surface carries an emulsion layer that keeps the mesh from touching the wafer directly. Full-area photoresist coating, by contrast, typically uses a screen without emulsion coverage so that resist is deposited evenly across the whole wafer, meaning the mesh comes into direct and extensive contact with the wafer on every printing cycle.
Earlier investigations cited by the researchers recorded a gradual efficiency decline from 26.2% to 25.7% across 15,000 consecutive printing cycles in commercial solar cell production. The losses were attributed mainly to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance were largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Wear at the mesh knuckles
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer grew, placing greater mechanical stress on the passivation layers beneath. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
To address the problem, the team developed an emulsion buffer layer that prevents the mesh from contacting the wafer surface directly. Six patterns were evaluated, with emulsion coverage ratios from 2.9% to 16.6%. The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution. A coverage ratio of 4.7% gave the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.
The improvement was attributed to the emulsion layer blocking direct contact between mesh and wafer, thereby reducing cumulative mechanical damage to the sensitive passivation layers. Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical route to improving manufacturing reliability for copper-plated HJT cells.
The study appears amid growing interest in copper metallization as an alternative to silver contacts in HJT devices. In April 2026, researchers at China's Nankai University reported a silver-free HJT solar cell with 25.2% efficiency, using plasma-induced interface engineering and copper electroplating to address adhesion, contact resistance and stability at the ITO interface. Separately, scientists at Germany's Forschungszentrum Jülich reached 23.08% efficiency in a fully copper-metallized HJT cell, a relatively small penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95%. Those results underline copper's potential to cut silver consumption, although further work on processing and electrical performance remains necessary.
