Automotive Accessories

Tremec's Manual C8 Corvette Development Car Shows What a Third Pedal Would Require

Astrid BerglundNovember 17, 20265 min read3 views

At a glance

  • A track drive of a one-off Peitz Performance C8 with Tremec's manual transaxle shows the conversion fits, but remote shift feel and a roughly $75,000 gearbox cost remain hurdles.
  • Tremec's one-off manual C8 development car has been driven on a private Michigan track, showing that a clutch pedal and transaxle can fit with limited structural changes. The review also highlights a less precise remote shifter, a track-only build and a gearbox cost that Tremec expects to fall with volume.
A cutaway-style illustration of an unnamed mid-engine sports car on a test track, highlighting a manual transaxle, clutch pedal and cable-linked shifter.

Tremec's manual-transmission C8 Corvette development car is not a rumor. It is a one-off Peitz Performance race car, and it was driven on a private track outside Howell, Michigan, called Motorsports Gateway. The car was built to test a new Tremec manual transaxle in a mid-engine Corvette, a combination Chevrolet did not offer when the C8 launched.

The C8 was a major change for Corvette: the first production version with the engine behind the driver, and the first offered only with a dual-clutch automatic. The review notes that developing two new transaxles for a mid-engine car would have been expensive, and it characterizes the decision to go automatic-only as a cost-driven marketing choice rather than an engineering impossibility. The reviewer's view is that GM prioritized comparison-test performance over a small group of manual enthusiasts.

A race car, not a showroom conversion

The test vehicle is a track build. Its interior finish is essentially absent, the shifter protrudes from the area normally used for the storage cubby and automatic gear selector, and the cabin has a full cage and harness. The seating position has virtually no adjustment; the reviewer, who is 5-foot-7, could not comfortably reach the pedals or brace against the floor, making heel-toe shifting awkward and limiting how hard the car could be pushed.

Even so, the conversion did not require major changes to the car's structure. The tunnel was cut to install clutch-pedal hardware, but the manual gearbox sits where the stock dual-clutch unit would, without special mating hardware. The pedal box also has enough room for a clutch pedal; the reviewer found it roomier than a previous-generation Camaro's setup even with the third pedal.

Remote shifter changes the feel

The manual transaxle does not feel exactly like a front-engine car with Tremec's TR-6060 six-speed. Because the shifter is remotely mounted and linked by cable to the gearbox at the rear, the reviewer found it slightly less precise and less notchy than the front-engine version. That can smooth out some of the Tremec's rougher edges, but it also removes some mechanical feel. Moving the engine forward or the shifter rearward would solve the issue, but either layout change would no longer be a C8.

Cost is the bigger obstacle

The gearbox alone was cited at about $75,000, which puts a manual C8 build in the price range of a showroom-spec Z06 when the cost of the car is included. Tremec says the price should fall as volume rises. The company also says OEMs are interested, not necessarily or exclusively General Motors, and that other automakers have asked about a high-torque manual transaxle. No automakers were named.

For now, the vehicle described is a development car, not a production C8 variant. The drive shows that the packaging is feasible and that a third pedal can fit, but it also shows the compromises: a remote shifter, a track-only build, a steep initial cost and the need for enough volume to bring the price down. For manual fans, the review argues, giving up a few tenths in acceleration or lap time may be a fair trade. For an automaker, the business case is less simple.

Reported by Astrid Berglund, Vehicle Cargo and Roof System Analyst.