Industrial Machinery

WITT to Present Gas Mixing and Safety Portfolio at FABTECH 2026

Priya RamanOctober 25, 20265 min read18 views

At a glance

  • The exhibit will focus on gas mixing, pressure regulation and safety components for industrial gas systems.
  • WITT Gas Controls plans to show its MEM+ gas mixers, dome pressure regulators and ULTRA/ULTRAVENT safety valves at FABTECH 2026, emphasizing precise blending, stable pressure and protection against backflow or overpressure. The company cites mixing accuracy better than ±1% absolute and pressure regulation features intended to support consistent industrial gas processes.
Concept illustration of a stainless steel gas mixing cabinet with pressure regulators, valves and piping in a bright industrial setting.

WITT Gas Controls plans to exhibit at FABTECH 2026, scheduled for October 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada. The company, which describes itself as a global leader in gas safety, control and analysis solutions, will use Booth S46114 to present gas mixers, dome pressure regulators and safety valves intended for precise mixing, stable pressure and system protection.

The MEM+ gas mixer series is designed to blend two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen, across industrial applications. Motorized proportional valves are electronically operated and can be adjusted in 0.1 percent increments. WITT says the system can reach a target mixture in less than three seconds, with accuracy better than ±1% absolute.

Integration and operating features

Seven interface options, including Ethernet, OPC UA and PROFINET, are offered for connection to existing systems. Operators can control the mixers remotely through a PC, PLC or machine controller, or locally through a touchscreen interface.

According to WITT, pressure equalization offsets fluctuations in supply pressure, while continuous inlet pressure monitoring and pressure alarms support safe operation. An integrated buffer tank is intended to accommodate changing flow rates. The MEM+ series is housed in a splash-proof, brushed stainless steel enclosure and supports maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

Pressure regulation and backflow protection

WITT will also highlight dome pressure regulators that use optimized pilot pressure regulators. The design is intended to maintain stable working pressure as flow rates and inlet pressures change, supporting consistent process performance and product quality. The company says the improvements can be retrofitted to existing WITT dome pressure regulators without replacing the entire system.

The display is also set to include ULTRA non-return valves and ULTRAVENT safety relief valves. ULTRA non-return valves are described as combining low opening pressures, tight sealing and minimal flow resistance to guard gas systems against unwanted backflow. ULTRAVENT safety relief valves are designed to protect against excessive pressure and respond to pressure increases as low as 5 mbar.

The featured equipment covers three functions within a gas system: blending gases to a specified ratio, holding working pressure steady as operating conditions shift, and protecting equipment from backflow or overpressure. WITT plans to present these functions at the show as complementary parts of its gas safety and control portfolio.

Reported by Priya Raman, Crane and Lifting Specialist.