Automotive Accessories

Zeph Gage Builds Budget Rear Portal Axle by Flipping Jeep Differential

Sofia MarchettiNovember 17, 20265 min read2 views

At a glance

  • A custom rear-only portal axle uses a flipped Ford 9-inch differential and Humvee geared hubs to add clearance at a fraction of typical cost.
  • Zeph Gage has developed a rear-only portal axle for an XJ Jeep by flipping a Ford 9-inch differential and combining Humvee geared hubs with custom adapters, reportedly costing about one-fifth of a typical $20,000 portal-axle set. The layout adds roughly six inches of clearance while preserving shock travel and avoiding front-end packaging constraints.
A conceptual editorial illustration of a custom off-road vehicle’s rear axle, showing a flipped differential, geared portal hubs and custom brackets in a workshop setting.

A custom off-road build by Zeph Gage shows how a rear-only portal axle can be assembled for far less than a typical commercial set. The project uses a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters, according to the report. Instead of buying a complete portal-axle system that can cost about $20,000, Gage’s setup is described as costing about one-fifth of that.

Why the differential is flipped

Portal axles place a stack of gears behind each driven wheel, allowing axle shafts to sit higher and reducing hardware hanging below the frame. Two-gear portals such as the Humvee units reverse the input shaft’s rotation. To make the Ford 9-inch work with that direction, Gage flipped the differential upside down so the driveline spins correctly. A Yukon Gear and Axle third member is then bolted to the differential, creating what the article describes as a budget high-pinion unit from low-pinion parts turned upside down.

Rear-only approach

Gage installed the portal axle only at the rear. That choice follows a common trick in remote-control rock crawling: keeping the front solid axle avoids the packaging constraints that can arise when adding portal axles to a vehicle that never had them from the factory. It also allows full shock travel to be retained and keeps ride height from rising excessively. The article says the arrangement is a best-of-both-worlds solution.

Clearance and durability claims

The conversion adds six inches of clearance and is said to retain full shock travel while reducing stress on the differential. The report describes the result as effectively bulletproof, although that is a characterization of the build rather than an independently tested result. With the rear axle raised, the XJ Jeep can drive over a five-gallon bucket and still have several inches of spare clearance, according to the article. That means the rear end is less likely to get hung up on obstacles that the front end can steer around.

Custom fabrication

The installation is not an off-the-shelf solution. Gage carried out substantial custom work, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it offers an integrated electric emergency-brake solenoid, as well as for clearance reasons. The article notes that more specifics, including how front and rear gearing were matched, are covered in a video from Outdoor Auto.

The build illustrates a lower-cost route to portal-axle clearance, but it depends on fabrication and component matching rather than a bolt-on kit. Its rear-only layout trades a front portal installation for packaging simplicity and preserved suspension travel, while still raising the rear axle enough to clear obstacles.

Reported by Sofia Marchetti, Interior Accessories and Fitment Analyst.